Judging a c-2 that originally was a 2 top conv.

[Paul J.]

Re: Judging a c-2 that originally was a 2 top conv.

Ron -

There will be two holes with stainless ferrules in them in the top surface of the deck lid, about 1" rearward of the rear edge of the soft top and 15-3/4" either side of the centerline. There will also be a hole with a threaded ferrule in it on both sides of the inboard edge of the deck lid, immediately rearward of the top linkage (with the soft top up).

IMG_0873.jpgIMG_0874.jpg

[Ronald F.]

Re: Judging a c-2 that originally was a 2 top conv.

This must be one of them. Not sure where to look for the other.

[Kenneth B.]

Re: Judging a c-2 that originally was a 2 top conv.

This must be one of them. Not sure where to look for the other.

Same place except on the other side. They are for the 2 screws that pertrude from the hard top & have washers & nutsto tighten the top down to the deck.

[Paul J.]

Re: Judging a c-2 that originally was a 2 top conv.

This must be one of them. Not sure where to look for the other.

See Post #32, posted 6 hours before your post.