Previous thread about N.Y. World's Fair car show got me looking into my old negs. This '64 fuelie convertible (white on red) was at the Canadian National Exhibition car show -- believe this was around Labor Day of 1963; could'a been as late as the Sportsman's show in Nov ?? [help me out you old T.O. guys]. Used Photobucket pic host, rather than puny DB pixel limits, so you A.R. guys can verify the correct valve stem-to-checkered flag clocking . Notice wheel weights on OUTSIDE rim (factory ?)
'64 Corvette at GM display -- Toronto, Fall '63
Collapse
X
-
Re: '64 Corvette at GM display -- Toronto, Fall '63
Nice picture, I'm guessing that was in the "Avtomotive Bvilding" during the Canadian National Exhibition. (Just a guess though as this is a bit before my time.)
As a kid I used to bug my dad to take me to that building to see the cars...much to my disappointment they had stopped using it for that.- Top
-
Re: '64 Corvette at GM display -- Toronto, Fall '63
The CNE [the "EX" as it was called] took place - in those years - in late August, ending on Labour Day. As this took place before the official introduction of the "new" models in late September and early October, the display of cars in the Automotive Building involved the cars with which were already familiar. Even as a young teenager, this made no sense to me. I wanted to see the new ones.
I distinctly remember a 64 Pontiac Parisienne convertible on display then. It was stunning. It was probably there at the very same time at this 64 Corvette!!!!- Top
Comment
-
Re: '64 Corvette at GM display -- Toronto, Fall '63
Previous thread about N.Y. World's Fair car show got me looking into my old negs. This '64 fuelie convertible (white on red) was at the Canadian National Exhibition car show -- believe this was around Labor Day of 1963; could'a been as late as the Sportsman's show in Nov ?? [help me out you old T.O. guys]. Used Photobucket pic host, rather than puny DB pixel limits, so you A.R. guys can verify the correct valve stem-to-checkered flag clocking . Notice wheel weights on OUTSIDE rim (factory ?)
Lot of restorers brush wide stripes of ugly yellow glue all around the w/strip area on the door.- Top
Comment
-
Re: '64 Corvette at GM display -- Toronto, Fall '63
I'm not 100% sure about the adhesive for the hood w/strip on a 67 though. That may have been a different adhesive but it still wasn't bright yellow.- Top
Comment
-
Re: '64 Corvette at GM display -- Toronto, Fall '63
I would have remembered and certainly complained, if there was highly visible amber glue on the doors. I often waxed the door jambs.
If you looked a little closer, you could see the glue but not easily.
Somewhere I have several pic's of the car and I think at least one or two are with the door open. I'll see if I can find it.- Top
Comment
-
Re: '64 Corvette at GM display -- Toronto, Fall '63
That doesn't look like a standard radio installed or it has some very strange reflections...
Also there is some cabling on the middle console, probably for lightning purposes...
regards,
RobRob.
NCRS Dutch Chapter Founder & Board Member
NCRS Software Developer
C1, C2 and C3 Registry Developer- Top
Comment
-
Re: '64 Corvette at GM display -- Toronto, Fall '63
Nice picture, also notice the nice rake of the car front to back. Many cars restored just don't look good because of this..- Top
Comment
Comment