1967 390hp Ignition Shield cover liner

[Todd G.]

I posted this a few weeks back and did not get any response . I checked the archives and could not find anything. So trying again to see if I can get some info.
Would appreciate it if anyone can provide me what the factory cuts/slits in the clear, glued-in liner should look like on the Ignition shield cover for '67 390 hp roadster. I understand there should be some 'perforations' (kind of look like dashed line slits I think) according to Judges at a recent NCRS Regional meet.
Thanks very much for any help.

[Edward S.]

Re: 1967 390hp Ignition Shield cover liner

I lack an original for my car, but 2 of my pals have them. You are correct it has a series of dash cuts in the liner. The fellows that have them both got them the same way, bought old rusted tops at vendor shows quite a long time ago. I keep looking, but so far have never run across one - have never even seen one on E-Bay. Good luck.

[Glenn B.]

Re: 1967 390hp Ignition Shield cover liner

I was told the liner should be "milky white" - not clear.

[Mike M.]

Re: 1967 390hp Ignition Shield cover liner

Hi Todd
Call me, I can talk you through it.
Hand

[Douglas L.]

Re: 1967 390hp Ignition Shield cover liner

Hope this picture helps a bit.