need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

[Mike M.]

ft wayne clutch has no cores available to rebuild one for me. thanks,mike

[Michael H.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

Would this help ?

http://www.ebay.com/itm/Chevrolet-Clutch-Borg-Beck-10-1-2-Pressure-Plate-Lightweight-/112078134799?hash=item1a18609e0f:g:w9UAAOSwnQhXnisu&vxp=mtr

Mike

[Mike M.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

thanks mike. will check on this one. mike

[Mark E.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

Non-oriental?

Do we need a PC sensitivity seminar?

[Loren L.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

Mike #14 IS a sensitivity seminar...........

[Curt S.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

Hi Mike. I have a pressure plate that the surface measures 10 1/2 inches. It says Borg-Beck Chicago and has a stamped number of 1594. It also has a stamped "rebuilt" also. Will this help? I am about 35 miles from Ft Wayne clutch so I can take it to them if that works. Thanks Curt

[Mike M.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

curt: thanks much for the help. if u take it to ft wayne for a rebuild, let me know what i owe you(u and ft wayne and shipping to cumberland. PM me your snail mail address andi'll send u a check. thanks again, mike

[Curt S.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

Hey Mike. I can get it to Ft Wayne early next week. I will have them inspect it to make sure it meets specs to rebuild. I am going to be gone for a while so I need your phone number to call you to work out details. Let me know a number and a good time to talk. Thanks Curt

[Mike M.]

Re: need source for non-oriental borg and beck 3 finger 10 1/2" pressure plate.

curt: any evening at 1 301 777 008nine. thanks,mike