If this is your first visit, be sure to check out the FAQ You must be an NCRS member before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below. If you have trouble logging in you can clear your cookies here!
I am changing the key cylinder on my 64 to a one hole unit.
When I removed the old unit there was some grease at the end.
Can someone tell me the best grease to utilize?
Jim, if there was a grease used it maybe something like dielectric grease, and would say not to put more that just a small dab as your dealing with electric contacts in the switch.
New England chapter member, 63 Convert. 327/340- Chapter/Regional/national Top Flight, 72 coupe- chapter and regional Top Flight.
Jim, did you replace the entire cylinder or just the chrome bezel? The old bezel should just pop off and pop on the one hole bezel. Just add a spot of silicone to hold in in place.
Ignition
Comment